Energy Saving Lamp Assembly Line

variety,structural diversity, wide range of uses

Introduction:

       Energy Saving Lamp Aging Line for general energy-saving lamp, ring lamp electronic ballast and energy saving straight sophisticated electronic ballast! Configure the device-specific E27 quick lamp, long life, easy to operate. Users can buy E14, B28-specific conversion speed lamp, suitable for production of many varieties of aging. Features: Central Andante chain drive up and down the structure, saving space; with special quick pull-type sockets, lights up and down easier;? Using isolation transformer means, the operational safety; transmission adopts imported inverter speed, more stable, low noise; all brush-type conductive contact with the new system, long life.

        Features: This device specific testing of finished products in sophisticated energy-saving lamps, energy-saving lamp tubes by high pressure, medium pressure, atmospheric pressure, low pressure, high temperature, roaming, voltage fluctuations and other areas of the sophisticated, energy-saving lamps observed a short circuit, explosion capacitance, Black, etc.. Beat detection circuits, analog roaming voltage area the use of energy-saving lamps. Power system frequency control system, easy to operate.

Basic configuration and construction:

    

1. Power: Electric products by Jiang Sheng Electric Co., Ltd. Jiangmen license 1.5KW motor, Taiwan Ashley brand Pa-100 1:80 a reducer, Taiwan imported Ed Lee 2HP frequency converter, frequency conversion stepless speed, line Adjustable speed 0-6M/min.     2. Fuselage frame: The frame is 50 × 40 × 1.5mm made of welded steel pipe; body with 130 × 23 × 2mm aging line of special aluminum alloy plates to the cold plate by bending productions 1.5mm Cheng, galvanized legs with adjustable foot cups.     3. Conveyor Chain: The chain factory produces the C212 Shanghai pitch one inch of the ear holes chain. Each 30 meters long.     4. Chain plate: 1.5mm cold plate bending by rolling into a 148 × 800 × 20mm, the entire line 140, each clip-board equipment 11 5 E27 E40 Romanian port and a lamp holder ceramic lamp holders; other supporting mount B22, E14 convert each lamp 300, and be equipped with MCB (joint venture, Foshan factory); chain installation Èr conductive bottom plate system (copper), each way to install the two conductive copper wire brush, each plate Total installed 4.     5. Output: the aging line can also age a 1656 energy-saving lamps, the aging time is about an hour; day by working 10 hour a day of production was 16 560 energy-saving lamps. (As the operating speed and operating speed / 4 complete)     6. Conductive groove: All up and down the groove with Èr conductive rail, using PVC insulated plastic tank, stainless steel conductive assembly 2mm × 35 section.     7. Block light dust cover: decent on-line block light dust cover set, using plexiglass plate and cold plate bending roll combination. Effective attenuation of light energy-saving lamps, better protect the eyes. Sealed cover to prevent dust from entering.     8. Protection of popular brands network: based one under the protection of popular brands online network, to prevent bad fall off lights, use high-quality stainless steel mesh with pore production.     9. Thermostatic zone: temperature electric heating system is completed, set two 2 2000W / sets of electric-type heating element, temperature, automatic temperature 30-80 °C, digital temperature control instructions.     10. Detection beat circuit: either set up an area for the beat control

Energy Saving Lamp Assembly Line